This is the highest quality water-based clear gloss finish available today. Its exceptional durability and abrasion resistance, coupled with very low odor and very low VOC make it the clear alternative to conventional solvent and water-based polyurethanes.
Your base coat(s) will always be gloss, but if you're wanting a lower sheen finish you can complete the project with the matte or satin finish.
USE ON: Unfinished (or properly prepared and sanded previously finished) floors, wooden furniture and cabinetry. Available in gloss and matte.
LIMITATIONS: Safecoat sealers are made without formaldehyde preservatives. Do not contaminate. Store in airtight containers. Do not use when indoor temperature is below 55 degrees F. Do not freeze. Thick application, high humidity or conditions other than normal will cause Safecoat to dry and cure more slowly. SURFACE
PREPARATION: Clean surfaces of dirt, grease, mildew and oil. Previously sealed surfaces should be sanded to promote adhesion (all gloss must be removed). Wet sanding is recommended. Surface should be completely dry before application. Always spot test for adhesion over prior coatings.
APPLICATION: Before using, roll the Safecoat Polyureseal BP container well, then apply as is. Stir product thoroughly every 20 minutes during application. Apply with a brush, pad or airless sprayer.
CLEAN UP: Clean tools and equipment while they are still wet with a warm soapy water solution.
DRYING/CURING TIME: Sandable after 2 - 4 hours, and re-coatable after 4 - 8 hours. The product will continue to cure and become harder over time. Normal conditions include a dry surface, access to fresh air flow, moderate humidity, and temperatures above 55 degrees F.
HEALTH PRECAUTIONS: As with all coatings and sealers, keep container tightly closed and out of the reach of children. Do not take internally. Keep from freezing. Always use adequate ventilation.
Physical Description: Milky, dries clear
% Volatile by Volume: 71.25%
Solubility in Water: Dilutable %
Volatile by Weight: 67.68%
VOC Material: 114 g/l
VOC Material less H20: 283 g/l
HAP’s (Hazardous Air Pollutants) zero