Acrylacq

Article number: AFM-51101
Availability: In stock

This clear water-based replacement for high-solvent content lacquer is hard and durable, with superior resistance to stains, marring and fingerprint marks.

Your base coat(s) will always be gloss, but if you're wanting a lower sheen finish you can complete the project with the matte or satin finish.

 

USE ON: Unfinished wooden cabinetry and doors, paneling, furniture, and wood railings, as well as some vinyl and other plastic surfaces (always test for compatibility with surface).

LIMITATIONS: Safecoat sealers are made without formaldehyde preservatives. Do not contaminate. Store in airtight containers. Do not use when indoor temperature is below 55 degrees F. Do not freeze. Thick application, high humidity or conditions other than normal will cause Safecoat to dry and cure more slowly.

SURFACE PREPARATION: Clean surfaces of dirt, grease, mildew and oil. Apply test patches before undertaking large areas to assure good adhesion and lack of surface contamination. Wood staining should be completed before applying finish coats.

APPLICATION: Before using, roll the Safecoat Acrylacq container well, then apply as is. Stir product thoroughly every 20 minutes during application. Apply thinly with a brush, pad or airless sprayer.

DRYING/CURING TIME: Sandable after 2 - 4 hours, and re-coatable after 4 - 8 hours. The product will continue to cure and become harder over time. Normal conditions include a dry surface, access to fresh air flow, moderate humidity, and temperatures above 55 degrees F.

HEALTH PRECAUTIONS: As with all coatings and sealers, keep container tightly closed and out of the reach of children. Do not take internally. Keep from freezing. Always use adequate ventilation.

PHYSICAL DATA:

Physical Description: Milky dries clear
% Volatile by Volume: 68.31%
Solubility in Water: Dilutable
% Volatile by Weight: 67.01%
VOC Material: 124 g/l
VOC Material less H20: 281 g/l
HAP’s (Hazardous Air Pollutants) zero

0 stars based on 0 reviews